Dew point monitor switching contact with external circuit board and display

The dew point monitor switching contact with external circuit board and display offers reliable protection against condensation forming on cold surfaces such as cooling pipes or cooling ceilings, combining an external circuit board with an easy-to-read display. The external sensor unit allows flexible installation in hard-to-reach or particularly sensitive locations, while the display allows direct on-site monitoring of the current temperature, humidity, and dew point values. The switching point can be set between 75 and 100% RH using a potentiometer (factory setting: 75%) and automatically activates the integrated output when exceeded. Integrated LEDs also indicate the current switching status. Ideal for HVAC systems, technical rooms, data centers, or industrial applications with increased monitoring and safety requirements.

Here you can find our downloads for Dew point monitor switching contact with external circuit board and display

	Data sheet Dew point monitor switching contact with external circuit board and display
	Instruction manual Dew point monitor switching contact with external circuit board and display
	Declaration of Conformity Dew point monitor switching contact with external circuit board and display

Dew point monitor - Supply and output
Output					Counter, 1 A ohmic load
Power consumption					< 1,1 VA / 24 V DC; < 2,2 VA / 24 V AC
Voltage supply					24 V AC (± 20 %) | 15 - 36 V DC
Connection type					See connection diagrams
Dew point monitor - General information
Pressure type					Dew point temperature
Measuring range humidity					75% RH to 100% RH switchable via potentiometer (75% RH delivery state)
Sensors					Digital humidity sensor with integrated temperature sensor, low hysteresis, high long-term stability
Sensor protection					Membrane filter
Long-term stability					± 1 % / year
Process connection					Cable tie, 200 mm (included)
Dew point monitor - Ambient conditions
Storage temperature					-35 °C to +85 °C
Operating temperature					-30 °C to +70 °C
Medium					clean air and non-aggressive, non-flammable gases
Dew point monitor - Certifications / Standards
Protection class					III (according to EN 60 730)
Protection type					IP 65 according to EN 60 529
Standards					CE conformity electromagnetic compatibility according to EN 61326 according to EMC Directive 2014/ 30/ EU
Dew point monitor - Technical drawing
Dew point monitor - Housing
Material					Plastic, UV-resistant Material polyamide, 30 % glass bead reinforced
Dimensions (L/W/H) (mm)					Aluminum die casting
Color					Traffic white (similar to RAL9016)
Electrical connection					0.14 - 1.5², via screw terminals on circuit board
Display					Two lines, lighted For displaying the actual humidity and the switching status of the switching contact (overrange, underrange, probe break, probe short-circuit)
Cut-out Display (B/H) (mm)					ca. 36 x 15
Closure					with quick release screws
Cover					transparent
Screw connection					Cable gland, Plastic, M20x1,5, Strain relief, replaceable, max. 10,4 mm Ø Inner
Dew point monitor - Cable
Cable material					PVC, LiYY
Cable length (m)					2
Color					White
Dew point monitor - External circuit board
Length (mm)					35
Width (mm)					15
Drill hole diameter (mm)					3
Dew point monitor - Important assembly instructions
The dew point monitor comes with an external circuit board that can be flexibly positioned using a 2 m long sensor cable – ideal for mounting on pipes or hard-to-reach areas. To ensure reliable operation, make sure there's good heat contact with the surface and that the sensor is free to be blown on by the ambient air.
Dew point monitor - Delivery
Delivery					Transmitter, Cable ties (200 mm), Operating instructions
Packing					individually packed in cardboard box