Set G1/4 " probe fitting connection

Our specially developed installation set for the secure installation of temperature sensors in indirekt installation offery you the perfect solution for professional installation in MID or existing immersion sleeves in energy meter systems, such as heat meters and cooling meters.

The set includes two G¼ sensor screw connections suitable for 6.0 mm probes.

Here you will find our downloads for the Set G1/4 " probe fitting connection

	Data sheet  Set G1/4 " probe fitting connection

Probe fitting connection energy meter - Probe fitting (2x)
Material					PEI
Color					Lightgrey
Dimensions (L/W/H) (mm)					16,5 x 16 x 18
Process connection					G1/4 "
Wrench size					15
for Ø sensor sleeve (mm)					6,0
Installation					for installation in MID or existing immersion sleeves
Maximum temperature (°C)					≤ 150
Note: The probe fitting has a sealing eyelet for attaching the measuring point seal.
Delivery and Assembly
Assembly instructions					for installation in existing immersion sleeves in accordance with MID
Delivery and Packaging					2x Probe fitting packaged in PE bag
Probe fitting connection energy meter - Important assembly advices
Proceed as follows when installing the sensor: • Use a new probe fitting for each installation. • When installing immersion sleeves, identical immersion sleeves must be used for each probe in a pair in terms of type, installation length and internal diameter. • The use of heat-conducting paste is not permitted. • The probes must be installed up to the bottom of the immersion sleeve. • The probes can also be designed for installation in long immersion sleeves. In this version, the clamping sleeve to be used may be located on the probe cable. Before installation, check that the correct cable clamping sleeve is used by measuring the immersion sleeve length. • Insert the probe into the half-shell of the probe fitting so that the rolling or press-on sleeve engages in the bars. • Close the probe fitting around the probe. • Screw the probe fitting together with the temperature probe hand-tight into the immersion sleeve. • A function test must be carried out at the end of each installation. • The probe must be sealed using the existing sealing points on the probe fitting. When installing temperature sensors in immersion sleeves in Germany, the list of tolerances issued by the PTB (Physikalisch-Technische Bundesanstalt) must be observed,and the immersion sleeves must be marked accordingly with their tolerance number.